M

Mr. Dubey • 100.64K Points
Coach

Q. The 'crowning' of flat pulleys is generally done

  • (A) To rduce the belt friction
  • (B) To prevent belt joint from damaging the belt surface
  • (C) To prevent the belt from running off the pulley
  • (D) In case of cross belt drives only
  • Correct Answer - Option(C)
  • Views: 400
  • Filed under category Machine Design
Share

No solution found for this question.
Add Solution and get +2 points.

You must be Logged in to update hint/solution

Discusssion

Login to discuss.

Related MCQs

Q. To create a hollow part, which of the following command would be most efficient

Q. The water tubes in a babcock and wilcox boiler are

Q. Bankrupt is one who

Q. Packed column distillation is limited to the column __________ metres.

Q. Instantaneous centre for a rolling wheel on a straight track will be at

Q. The longitudinal wave incident angle at which the refracted shear wave angle equals ninety degrees is called:

Q. Which of the following is not under direct measurement?

Q. The incubation period of Typhoid bacillus causing typhoid fever is

Q. If the power factor of an electrical system is unity, it means

Q. The penetrating power of an X ray machine is indicated by:

Question analytics