M

Mr. Dubey • 100.64K Points
Coach

Q. Why neck section provided in the pull type broaches are made shorter in diameter?

  • (A) To provide better surface finish
  • (B) To remove chips easily
  • (C) To allow failure in case of overloading
  • (D) For holding purpose
Share

No solution found for this question.
Add Solution and get +2 points.

You must be Logged in to update hint/solution

Discusssion

Login to discuss.

Related MCQs

Q. In hydrothermal systems when steam water and dissolved solids are available as source of energy, the entrained solids are removed by

Q. At a given equilibrium pressure, with increase in temperature, the concentration of adsorbed gas on solid adsorbent

Q. Which type(s) of sound wave modes will propagate through solids?

Q. For contacting a highly soluble gas with a liquid

Q. Mottling of teeth is associated with the presence of

Q. The following is basically a material flow simplification technique

Q. In worm, gears, pitch lead angle is

Q. 5 FUEL AND ASH HANDLING

Q. A residual circular field may be objectionable because:

Q. Intercooling in multistage compressors is done

Question analytics