R

Ram Sharma • 193.88K Points
Coach

Q. __________ test can be termed as the semi-distructive test.

  • (A) Impact
  • (B) Torsion
  • (C) Hardness
  • (D) Charpy
Share

No solution found for this question.
Add Solution and get +2 points.

You must be Logged in to update hint/solution

Discusssion

Login to discuss.

Related MCQs

Q. Addition polymerisation takes place either by a free radical mechanism or ionic machanism depending on the reagents used. Free radical polymerisation

Q. Which of the following fuel gases is heavier than air?

Q. Which type of heat exchanger is preferred for heavy heat loads?

Q. In hot wire aneomometer used for gas flow measurement, the wire is normally made of

Q. Optimum preheating temperature for pitch creosote mixture (PCM) which is also termed as C.T.F-200, before atomisation through burners is

Q. Overall heat transfer co-efficient of a particular tube is U1. If the same tube with some dirt deposited on either side has coefficient U

Q. Detergent is added as an additive in engine lubricating oil to

Q. Ceramic materials are

Q. _____ stress cannot be sustained by a fluid in equilibrium.

Q. The normal range of velocity of steam in pipes is _______ m/sec.

Question analytics