M

Mr. Dubey • 100.64K Points
Coach

Q. A method of compensating for the ‘dead zone’ or near surface resolution problems is to:

  • (A) Inspect all areas of the test piece twice to assure repeatability of indications
  • (B) Re-inspect from the opposite side of the test piece if geometry permits
  • (C) Re-inspect using a higher energy pulse
  • (D) Re-inspect using a higher frequency transducer that does not have a ‘dead
Share

No solution found for this question.
Add Solution and get +2 points.

You must be Logged in to update hint/solution

Discusssion

Login to discuss.

Related MCQs

Q. A spring is used to

Q. The torque developed by a 3-phase induction motor during starting

Q. Heat transfer by conduction results due to the transfer of free electrons, kinetic energy & vibrational energy from one molecule to another. Condu

Q. In which of the following unit operations, the selectivity is an important parameter?

Q. Which of the following can be used as an argument for a procedure parameter?

Q. For a self locking lifting machine, the efficiency must be

Q. A number of forces acting at a point will be in equilibrium if

Q. Which of the following gases are used in Tungsten inert gas welding?

Q. Which of the following cast materials could most likely be successfully ultrasonically tested?

Q. Brake lining is mounted on

Question analytics