📊 Fluid Mechanics
Q. Dimension of surface tension is (where, F = force, L = length)
  • (A) F.L-1
  • (B) F-1.L
  • (C) F.L-2
  • (D) F-2.L
💬 Discuss
✅ Correct Answer: (A) F.L-1

You must be Logged in to update hint/solution

💬 Discussion

Related MCQs

Q. Aromatics are desired constituents of

Q. I.D. of 1/4" schedule 40 pipe is 0.364". I.D. of a 1/2" schedule 40 pipe would be __________ inch

Q. Nusselt number for full developed, laminar, constant property flow in a pipe at uniform heat flux is

Q. Octane number of gasoline produced by two stage fluidised catalytic cracking process is

Q. 'Lang factor' is defined as the ratio of the capital investment to the delivered cost of major equipments. The value of 'Lang factor' for fixed capita

Q. Sensible heat absorbed by 1 lb of water when it is heated from 32 to 212°F may be around __________ BTU.

Q. The heating capacity of continuous reheating furnace depends upon the

Q. An example of indirectly heated furnace is the

Q. In a manufacturing industry, break even point occurs, when the

Q. The depreciation during the year 'n', in diminishing balance method of depreciation calculation, is calculated by multiplying a fixed percentage 'N' t

📊 Question Analytics

👁️
700
Total Visits
📽️
3 y ago
Published
🎖️
Ram Sharma
Publisher
📈
90%
Success Rate