Q. The addition of antimony in tin-based alloys improves its

  • (A) Rupture strength and hot hardness
  • (B) Impact strength and bonding strength
  • (C) Deformation resistance
  • (D) Wear resistance
💬 Discuss
✅ Correct Answer: (C) Deformation resistance

Published by Ram Sharma ⭐ 193.88K Points at 12-May-2023 05:00 pm in Materials And Construction

You must be Logged in to update hint/solution

💬 Discussion

Related MCQs

Q. If fuel and air are mixed ahead of the burner, it is called a/an __________ burner.

Q. If the flame is produced under the hearth and then sweeps up into the heating chamber, this is called a/an __________ furnace.

Q. Pick out the wrong statement about a streamline.

Q. Bakelite is a/an

Q. For maximum discharge through a chimney, its height should be

Q. Addition of nickel to copper improves its

Q. It is not recommended to use a 1-2 shell and tube heat exchanger for a particular heat duty, whenever the LMTD correction factor is

Q. Percentage elongation of a material is a measure of its

Q. Heat penetration rate in narrow coke ovens in high temperature carbonisation of coal is around __________ cm/hr.

Q. "Break-even point" is the point of intersection of

📊 Question Analytics

👁️
761
Total Visits
📽️
3 y ago
Published
🎖️
Ram Sharma
Publisher
📈
90%
Success Rate