Q. Dies for wire drawing are generally made of

  • (A) Mild steel
  • (B) Carbides
  • (C) High carbon steel
  • (D) Stainless steel
💬 Discuss
✅ Correct Answer: (B) Carbides

Published by Ram Sharma ⭐ 193.88K Points at 12-May-2023 05:18 pm in Materials And Construction

You must be Logged in to update hint/solution

💬 Discussion

Related MCQs

Q. 'Cryogenics' is concerned with the generation & use of low temperature in the range of

Q. For the flow of gases through a capillary, with increase in temperature, the permeability __________ as per Knudsen law.

Q. Thermal efficiency of a limestone calcination rotary kiln may be around __________ percent.

Q. The heating capacity of muffle furnace depends on the

Q. Which of the following pipe bends will incur the largest head loss ?

Q. Straight silicon steel (containing Si from 0.5 to 5%) because of their low hysterisis loss and high magnetic permeability are used for electrical appl

Q. The non-dimensional temperature gradient in a liquid at the wall of a pipe is the

Q. Fermenter used in the production of pen-cillin by deep fermentation proces is a __________ lined steel vessel

Q. Which of the following coke has the least percentage of ash?

Q. For maximum discharge through a chimney, its height should be

📊 Question Analytics

👁️
727
Total Visits
📽️
4 y ago
Published
🎖️
Ram Sharma
Publisher
📈
96%
Success Rate