R

Ram Sharma • 193.88K Points
Coach

Q. A coal with high ash content is undesirable, as

  • (A) It is abrasive to the coal pulveriser (ie.g. ball mill) and the combustion chamber
  • (B) The ash in molten condition gets absorbed in the pores of the refractory lining of the furnace and causes its spalling due to different co-efficient of expansion/contraction of the refractory and the ash
  • (C) The ash retains the sulphur & phosphorus and thus affects the quality of products in metallurgical furnace apart from increasing the slag volume. Besides, it may fuse and stick to the boiler tubes thereby reducing the heat transfer
  • (D) All of the above
Share

No solution found for this question.
Add Solution and get +2 points.

You must be Logged in to update hint/solution

Discusssion

Login to discuss.

Related MCQs

Q. Higher furnace temperature can not be achieved by use of a lean fuel gas in the furnace by

Q. Steam is to be condensed in a shell and tube heat exchanger, 5 m long with a shell diameter of 1 m. Cooling water is to be used for removing the heat.

Q. __________ can replace tungsten in high speed steel,

Q. Brine solution is stored/treated in __________ lined vessels/pipes.

Q. Dearomatisation of kerosene (by liquid sulphur dioxide extraction) is done to

Q. __________ is an addition polymer.

Q. Which of the following is a component of working capital investment?

Q. In forced convection, the heat transfer depends on

Q. The calorific value of 'LPG' (50% propane + 50% butane) is about __________ kcal/Nm3.

Q. Which of the following equipments is not used in liquid-liquid extraction?

Question analytics