M

Mr. Dubey • 100.64K Points
Coach

Q. In a d.c. machine, the armature mmf is

  • (A) stationary w.r.t. armature.
  • (B) rotating w.r.t. field.
  • (C) stationary w.r.t. field.
  • (D) rotating w.r.t. brushes.
Share

No solution found for this question.
Add Solution and get +2 points.

You must be Logged in to update hint/solution

Discusssion

Login to discuss.

Related MCQs

Q. NC contouring is an example of

Q. ____ grippers are used to pick up light weight materials such as paper,cloth etc

Q. In economics of nuclear power plant taxes and insurance charges are taken as

Q. Which of the following can have octane rating of more than 100?

Q. The temperature to which a vapour gas mixture must be cooled (at varying humidity) to become saturated is called the __________ temperature.

Q. An economiser is installed in a boiler plant primarily to

Q. Which of the following cannot take radial load?

Q. The design calculations for members subject to fluctuating loads with the same factor of safety, yield the most conservative estimates when using

Q. If the tearing efficiency of a riveted joint is 75%, then the ratio of diameter of rivet to the pitch is equal to

Q. Under Gantt incentive plan the wages are calculated on

Question analytics