📊 Electrical and Electronics Engineering
Q. The maximum voltage is induced in the rotor of 3-ph induction motor when it----
  • (A) runs at no load
  • (B) runs at full load
  • (C) is blocked
  • (D) none of the above
💬 Discuss
✅ Correct Answer: (A) runs at no load

You must be Logged in to update hint/solution

💬 Discussion

Related MCQs

Q. The statement that the sum of the kinetic and potential energies of a particle in the earth's gravitational field is constant is known as

Q. Indications which are caused by design or construction of the test piece are called?

Q. The permissible stress in the fillet weld is 100 N/mm². The fillet weld has equal leg lengths of 15 mm each. The allowable shearing load on the w

Q. Which of the following short-circuit is the most dangerous?

Q. For acid resistance cast iron should have silicon percentage of

Q. The casting process that does not require a core to produce a hollow casting is?

Q. Two plates are joined by a parallel fillet welds. The plates are subjected to a tensile load of 35000 kg. If the allowable shear stress for the weld m

Q. The ends of the coil of compression spring which are in contact with the seat are

Q. Thermal conductivity of air at room temperature in kcal/m hr °C is of the order of

Q. In a laboratory test run, the rate of drying was found to be 0.5 x 10-3 kg/m2 .s, when the moisture content reduced from 0.4 to 0.1 on dry basis. The

📊 Question Analytics

👁️
914
Total Visits
📽️
3 y ago
Published
🎖️
Mr. Dubey
Publisher
📈
87%
Success Rate