📊 Engineering Metallurgy
Q. one of the following is main purpose of Normalizing
  • (A) to improve machinability
  • (B) to modify and refine grain
  • (C) to homogenize the microstructure
  • (D) all of the above
💬 Discuss
✅ Correct Answer: (D) all of the above

You must be Logged in to update hint/solution

💬 Discussion

Related MCQs

Q. In an actual SI engine the pumping loss with respect to speed

Q. The x coordinate of the centroid of the area enclosed by the parabolas y = x2 and x = y2 will be

Q. Proper functioning of a strain gauge depends on

Q. Which of the following is not related to the geometrical accuracy of CMM?

Q. For Q 45, Tangent vector for line L2

Q. Low utilization factor for a power plant indicates that

Q. In case of clutch if the springs become weak, the remedy lies in

Q. Which of the following statement with respect to food preservation is true?

Q. If the number of poles in a lap wound generator be doubled, then the generated e.m.f will_________.

Q. Temperature of heat rejection in a condenser can be lowered by using?

📊 Question Analytics

👁️
468
Total Visits
📽️
3 y ago
Published
🎖️
Mr. Dubey
Publisher
📈
90%
Success Rate