N

Nisha Gupta • 2.32K Points
Master

Q. A propeller agitator

  • (A) Produces mainly axial flow
  • (B) Is used for mixing high viscosity pastes
  • (C) Runs at very slow speed (2 rpm)
  • (D) All (A), (B) and (C)
Share

No solution found for this question.
Add Solution and get +2 points.

You must be Logged in to update hint/solution

Discusssion

Login to discuss.

Related MCQs

Q. Calburn analogy is applicable for the value of Prandtl number from

Q. Bomb calorimeter is used to determine the (where, GCV - Gross Calorific Value. NCV - Net Calorific Value.)

Q. Isotropic materials have the same __________ in all directions.

Q. __________ are produced by reacting polybasic acid (e.g. phthalic anhydride) with polyhydric alcohol (e.g., glycerol).

Q. Which of the following furnaces will have maximum thermal efficiency?

Q. Failure of a material is termed as fatigue failure, if it fails below the yield point. The resistance to fatigue failure of a material is measured by

Q. ______ property of steel increases by addition of large amount of silicon in it.

Q. Gross heating value of coal is __________ the net heating value.

Q. If a single tube pass heat exchanger is converted to two pass, then for the same flow rate, the pressure drop per unit length in tube side will

Q. Both asphalt and wax are produced by __________ base crude oils.

Question analytics