📊 Materials And Construction
Q. Which of the following is produced by addition polymerisation?
  • (A) Polybutadiene
  • (B) Dacron
  • (C) Urea-formaldehyde
  • (D) Phenol formaldehyde
💬 Discuss
✅ Correct Answer: (A) Polybutadiene

You must be Logged in to update hint/solution

💬 Discussion

Related MCQs

Q. "Break-even point" is the point of intersection of

Q. Cast iron is having very high

Q. Manufacturing cost in a chemical company does not include the

Q. Effective and nominal interest rates are equal, when the interest is compounded

Q. The approximate liquid depth in an agitation tank is equal to (where, d = tank diameter)

Q. Which is a fertile nuclear fuel?

Q. Which of the following is concerned with both heat and mass transfer?

Q. Actual flame temperature is always lower than the adiabatic flame temperature, because there is

Q. The non-dimensional temperature gradient in a liquid at the wall of a pipe is the

Q. Maximum acceptable total liquid gradient over a tray is about __________ mm.

📊 Question Analytics

👁️
64
Total Visits
📽️
3 y ago
Published
🎖️
Ram Sharma
Publisher
📈
82%
Success Rate