Q. In case of Vee belt

  • (A) The belt should not touch the bottom of groove in the pulley
  • (B) The belt should touch the bottom of groove in the fulley
  • (C) The efficiency of transmission is less
  • (D) Grooves in the pulley are generally wider than the belt
💬 Discuss
✅ Correct Answer: (A) The belt should not touch the bottom of groove in the pulley

Published by Mr. Dubey ⭐ 104.84K Points at 20-Sep-2023 12:38 pm in Machine Design

You must be Logged in to update hint/solution

💬 Discussion

Related MCQs

Q. Rayleigh equation applies to __________ distillation.

Q. If the number of poles in a lap wound generator be doubled, then the generated e.m.f will_________.

Q. Which of the following can be calculated theoretically using steam table and Dalton's law of partial pressure; if the relative humidity and dry bulb t

Q. The theory of failure generally applied in case of brittle materials is

Q. When using a post emulsifiable penetrant process, it is important to drain as much excess penetrant as possible from the surface of a test piece which

Q. Thermal conductivity of air at room temperature is approximately

Q. Which type of fins are the most commonly used fin type in condensers?

Q. The degree of perfection used in instruments, techniques are observations is known as

Q. In a boundary lubricated bearing, there is a __________ of lubricant between the journal and the bearing.

Q. A 4 pole, 500V shunt motor has 720 wave connected conductors on its armature. The full load armature current is 60A and flux per pole is 0.03Wb. The a

📊 Question Analytics

👁️
316
Total Visits
📽️
3 y ago
Published
🎖️
Mr. Dubey
Publisher
📈
82%
Success Rate