M

Mr. Dubey • 100.64K Points
Coach

Q. In lathe work, when the tool is fed parallel to the rotation of job work, it will produce

  • (A) Cylindrical surface
  • (B) Spherical surface
  • (C) Tapered surface
  • (D) All of the above
Share

No solution found for this question.
Add Solution and get +2 points.

You must be Logged in to update hint/solution

Discusssion

Login to discuss.

Related MCQs

Q. In commercial vehicle layouts engine is located forward, rear or under floor mainly to

Q. How many percentage of fissionable U-235 occurring in uranium?

Q. The land area required for installation of nuclear power plant is

Q. The plastic design of steel structures which is based on upper bound theorem is

Q. In a single effect evaporator, the economy is

Q. The 'dead time' of the instrument is

Q. The centre distance between two meshing involute gears is equal to

Q. Splined shafts are commonly used in

Q. In saturated gas, the

Q. Which of the following code will give point to point movement?

Question analytics