Q. Alumina, silica, lime and iron oxide are the basic raw material for the manufacture of portland cement. The component of Portland cement which first hardens is

  • (A) 5CaO . 3Al2O3
  • (B) 3CaO . Al2O3
  • (C) 3CaO . SiO2
  • (D) 2CaO . SiO2
💬 Discuss
✅ Correct Answer: (A) 5CaO . 3Al2O3

Published by Ram Sharma ⭐ 193.88K Points at 30-May-2023 06:34 pm in Chemical Engineering Basics

You must be Logged in to update hint/solution

💬 Discussion

Related MCQs

Q. Ammonium sulphate can be produced by reacting gypsum with

Q. Profit is equal to revenue minus

Q. The length of the tube necessary for the boundary layer to reach the centre of the tube and for fully developed flow to be established is called the _

Q. Mass transfer rate between two fluid phases does not necessarily depend on the __________ of the two phases.

Q. Calorific value of wood gas is about __________ kcal/Nm3.

Q. In a shell and tube heat exchanger, putting a longitudinal baffle across the shell, forces the shell side fluid to pass __________ through the heat ex

Q. With increase in temperature, the electrical conductivity of the platinum used in the resistance thermometer

Q. Design of waste heat boiler for recovery of waste heat from furnace gases depends upon the

Q. Mixing vessel used for the chlorination of methane to produce methyl chloride is made of

Q. Function of air vessel provided in a reciprocating pump is to

📊 Question Analytics

👁️
682
Total Visits
📽️
3 y ago
Published
🎖️
Ram Sharma
Publisher
📈
84%
Success Rate