M

Mr. Dubey • 100.64K Points
Coach

Q. During milling, the cutter usually moves

  • (A) Perpendicular to its axis
  • (B) Parallel to its axis
  • (C) Inclined to its axis
  • (D) Any of the above
Share

No solution found for this question.
Add Solution and get +2 points.

You must be Logged in to update hint/solution

Discusssion

Login to discuss.

Related MCQs

Q. Steam distillation is used for separation of high boiling

Q. During dehumidification of unsaturated air wet bulb temperature & partial pressure of vapor are not constant. However, during evaporative cooling

Q. The low no load power factor

Q. What is used to heat the feed water which is used for recirculation through tubes?

Q. The ratio of heat transfer coefficient to the flow of heat per unit temperature rise due to the velocity of the fluid is known as

Q. While top surface of an overfeed stoker consists of

Q. IC engine cylinders are lubricated by

Q. The flow through turbine on a Mollier chart is represented by

Q. For what value of Prandtl number, St = f/2?

Q. According to I.B.R., the efficiency of a triple riveted butt joint with double straps of unequal width (5 rivets per pitch length) should be

Question analytics