Q. A locking device in which the bottom cylindrical portion is recessed to receive the tip of the locking set screw is called

Related MCQs

Q. A generating station is to supply four regions of loads with peak demands of 10 MW, 15 MW, 20 MW and 30 MW. If the diversity factor is 1.5 the maximum

Q. By technological innovations if the cost of raw material is reduced, this will result in

Q. Out of the given option choose the advantage that supports fire tube boilers?

Q. Which of the following statement is correct?

Q. Which material is present above the upper critical temperature line in an iron carbon phase diagram?

Q. Which element of hydroelectric power plant prevents the penstock from water hammer phenomenon?

Q. Mass transfer rate between two fluid phases does not necessarily depend on the __________ of the two phases.

Q. Flow in an open channel can be measured by

Q. A residual field is always less than a continuous field because?

Q. Rubber forming is a type of forming process in which polyurethane is used as a die material.