📊 Machine Design
Q. The limit design of steel structures makes use of
  • (A) elastic and plastic analysis of structures
  • (B) ultimate analysis
  • (C) Increasing the diameter of threaded portion
  • (D) plastic analysis of structures
💬 Discuss
✅ Correct Answer: (D) plastic analysis of structures

You must be Logged in to update hint/solution

💬 Discussion

Related MCQs

Q. The Clapeyron equation is applicable for

Q. Calculate the compensator rating required for a sec(Φ)=1.

Q. The ideal output velocity of steam from a nozzle having an enthalpy drop of 100 kcal/kg will be

Q. Protection from radiations is possible through

Q. The tensile stress in the flywheel rim due to the centrifugal force acting on the rim is given by

Q. When acetone is added in a two layer mixture of methyl isobutyl ketone and water at 30°C, the acetone distributes between the two layers and the c

Q. The ability to separate echoes from reflectors close together in depth is called:

Q. Open pan evaporators are preferred to be used, when the solution to be concentrated is

Q. Calculate the refracted shear wave angle in steel [VS = 0.323cm/microsec] for an incident longitudinal wave of 37.9 degrees in Plexiglas [VL = 0.267cm

Q. According to I.B.R., the factor of safety of riveted joint should not be less than

📊 Question Analytics

👁️
736
Total Visits
📽️
2 y ago
Published
🎖️
Mr. Dubey
Publisher
📈
81%
Success Rate