📊 Machine Design
Q. A stud has
  • (A) Counter shunk head
  • (B) Allen head
  • (C) Slotted head
  • (D) Both ends threaded
💬 Discuss
✅ Correct Answer: (D) Both ends threaded

You must be Logged in to update hint/solution

💬 Discussion

Related MCQs

Q. Every material obeys the Hooke's law within

Q. A composite flat wall of a furnace is made of two materials 'A' and 'B'. The thermal conductivity of 'A' is twice of that of material 'B', while the t

Q. The slip recovery scheme is a part of the synchronous speed changing technique.

Q. For achieving rapid drying rate in a spray dryer, the diameter of the particles in the feed should be in the range of __________ microns (1 mm = 1000

Q. some materials can not be work hardened at normal ambient temp. such as …….. Material.

Q. Lead screens improve mainly the of the final radiograph:

Q. A generating station is to supply four regions of loads with peak demands of 10 MW, 15 MW, 20 MW and 30 MW. If the diversity factor is 1.5 the maximum

Q. In power station practice 'spinning reserve' is

Q. The ratio of endurance limit in shear to the endurance limit in flexure is

Q. Which one of the following statements is TRUE?

📊 Question Analytics

👁️
389
Total Visits
📽️
2 y ago
Published
🎖️
Mr. Dubey
Publisher
📈
93%
Success Rate