📊 Machine Design
Q. The critical pressure of the journal bearing is
  • (A) at which oil film breaks down
  • (B) metal to metal contact begins
  • (C) minimum operating pressure of the bearing
  • (D) none of the above
💬 Discuss
✅ Correct Answer: (A) at which oil film breaks down

You must be Logged in to update hint/solution

💬 Discussion

Related MCQs

Q. In a belt drive, if the pulley diameter is doubled keeping the tension and belt width constant, then it will be necessary to

Q. Two successive translations are

Q. For absorbers, high pressure drop results in

Q. The principle on which a disappearing filamment type pyrometer works is known as

Q. Soderberg relation is based on __________ of the material whereas all other failure relation for dynamic loading are based on ultimate strength of the

Q. Brayton cycle cannot be used in reciprocating engines even for same compression rations and work output because

Q. (NSh/NRe.NSc) is termed in mass transfer operation as the

Q. Large sections usually have a somewhat lower permissible stress than small sections. This is due to

Q. Air standard efficiency of an I.C. engine depends on

Q. Mixing of fuel and air in case of a diesel engine occurs in

📊 Question Analytics

👁️
376
Total Visits
📽️
3 y ago
Published
🎖️
Mr. Dubey
Publisher
📈
98%
Success Rate