M

Mr. Dubey • 100.64K Points
Coach

Q. Which of the following is true in case of “too quick” forming (too few passes)?

  • (A) it makes the tooling and the process uneconomical
  • (B) it makes process easier
  • (C) it distorts the product
  • (D) eliminate the need of a skilled operator
Share
Explanation by: Mr. Dubey
“too quick” forming (too few passes) will distort the product because of the unacceptable level of stresses generated in the metal. on the other hand, too many passes will make the tooling and the process uneconomical.

You must be Logged in to update hint/solution

Discusssion

Login to discuss.

Related MCQs

Q. Which of the following is not the same as watt?

Q. The relation between number of pairs (p) forming a kinematic chain and the number of links ($$l$$) is

Q. The defect blow hole in castings is caused due to

Q. Essential requirement for the transfer of heat from one body to another is

Q. Which of the processor’s stack does not contain the top-down data structure?

Q. For the same power and same speed, the flywheel of a two stroke engine as compared to that of a four stroke engine will be

Q. When an unsaturated air-water mixture is heated at constant pressure, then

Q. The rate of energy stored in the wall will be

Q. circuit

Q. Which of the following is an indirect method of pressure measurement?

Question analytics