📊 Manufacturing Technology
Q. What is the maximum pressure required in a compression molding process?
  • (A) 35 mpa
  • (B) 40 mpa
  • (C) 45 mpa
  • (D) 50 mpa
💬 Discuss
✅ Correct Answer: (D) 50 mpa

Explanation: the maximum pressure that is required for the complete operation of compression molding is 50 mpa.

Explanation by: Mr. Dubey
the maximum pressure that is required for the complete operation of compression molding is 50 mpa.

💬 Discussion

Related MCQs

Q. The ratio of the actual efficiency and the fuel-air cycle efficiency for CI engines is about

Q. If number of conductors in a dc generator is Z then total number of turns are

Q. Compression efficiency is compared against

Q. Which of the following is true for an open heater?

Q. All metallic engineering materials which are can be friction welded.

Q. For a twin cylinder V-engine, the crank positions for primary reverse cranks and secondary direct cranks are shown in the below figure. The engine is

Q. The reciprocal of thermal conductivity is known as __________

Q. A grinding wheel rotates at 3000 rpm. When power supply is cut off the wheel stops in 5 sec. The number of revolutions made by the wheel before coming

Q. Packed column distillation is limited to the column __________ metres.

Q. Which of the following industrial process uses waste as a fuel?

📊 Question Analytics

👁️
463
Total Visits
📽️
2 y ago
Published
🎖️
Mr. Dubey
Publisher
📈
82%
Success Rate