Q. In compression molding, the curing time does not depend on which of the following factors?

  • (A) material
  • (B) curing temperature
  • (C) geometry
  • (D) thickness
💬 Discuss
✅ Correct Answer: (B) curing temperature
Explanation: when there has to be molding done for thermosetting materials, mainly compression molding is preferred. while doing this, curing has to be done. the time needed for curing depends on the material used, geometry and thickness of the material.

Published by Mr. Dubey ⭐ 109.99K Points at 20-Sep-2023 12:46 pm in Manufacturing Technology

Explanation by: Mr. Dubey
when there has to be molding done for thermosetting materials, mainly compression molding is preferred. while doing this, curing has to be done. the time needed for curing depends on the material used, geometry and thickness of the material.

💬 Discussion

Related MCQs

Q. When two non-intersecting and non-coplanar shafts are connected by gears, the arrangement is known as

Q. The critical value at which crack extension occurs is called

Q. Turbidity of water is usually measured in terms of

Q. Fuel-air ratio affects maximum power output of the engine due to

Q. Pick out the wrong statement:

Q. The alternators for a steam power plant usually run at

Q. Increasing the temperature of intake air in an I.C. engine will

Q. The ability of material to absorb a large amount of energy is

Q. A bullet is fired vertically upwards with a velocity of 2200 ft/s. Bullet ascends to a height of

Q. If a clearance fit is present between shaft and hole, what is the tolerance on shaft or hole for a complete interchangeable approach?

📊 Question Analytics

👁️
657
Total Visits
📽️
3 y ago
Published
🎖️
Mr. Dubey
Publisher
📈
80%
Success Rate