Q. Which of the following material is not made by injection molding?

  • (A) nuts
  • (B) tubes
  • (C) car handles
  • (D) electrical fittings
💬 Discuss
✅ Correct Answer: (B) tubes
Explanation: injection molding is one of the most widely used method of molding among molding with polymers. there are various applications of this method such as nuts, bolts, cups, car handles, electrical fitting parts, but not tubes and rods.

Published by Mr. Dubey ⭐ 111.54K Points at 20-Sep-2023 12:46 pm in Manufacturing Technology

Explanation by: Mr. Dubey
injection molding is one of the most widely used method of molding among molding with polymers. there are various applications of this method such as nuts, bolts, cups, car handles, electrical fitting parts, but not tubes and rods.

💬 Discussion

Related MCQs

Q. Plastic flow in ductile materials

Q. Any point on a link connecting double slider crank chain will trace a

Q. Flux density is a measure of the number of magnetic flux lines perpendicular to an area of cross-section. If a discontinuity is in the plane of the un

Q. Which of the following is true for the multiple start screw threads?

Q. When the back pressure of a nozzle is below the critical pressure, the nozzle is said to be

Q. Rotary compressor is best suited for

Q. For the same process conditions, the reflux ratio of an unlagged distillation column

Q. Two pulleys of radii r1 and r2 and at distance x apart are connected by means of a cross belt drive. The length of the belt is

Q. When using a post emulsifiable penetrant process, it is important to drain as much excess penetrant as possible from the surface of a test piece which

Q. Which of the following is one of the design process steps?

📊 Question Analytics

👁️
1046
Total Visits
📽️
3 y ago
Published
🎖️
Mr. Dubey
Publisher
📈
99%
Success Rate