M

Mr. Dubey • 100.64K Points
Coach

Q. In blow molding, to inflate soft plastic, which medium is used?

  • (A) air
  • (B) water
  • (C) oil
  • (D) alcohol
Share
Explanation by: Mr. Dubey
blow molding process is typically used for the blowing process of hollow plastics. while blow molding, the plastic has to be inflated, in order to do so, air has to be blown inside with a high amount of pressure.

You must be Logged in to update hint/solution

Discusssion

Login to discuss.

Related MCQs

Q. The alternators for a steam power plant usually run at

Q. Which is the most suitable for the concentration of foamy & frothy liquors?

Q. A DC series motor is most suitable for _____.

Q. Which of the following is not afundamental quantity?

Q. In a counter-current extractor, as the axial mixing increases, the extraction efficiency

Q. A ball A of mass 0.25 kg moving on a smooth horizontal table with a velocity of 10 m/s strikes an identical stationary ball B on the table. If the imp

Q. Which fuel is produced by powdering low grade coal with high ash content?

Q. Which system is noisy out of all the following ash handling systems?

Q. Percentage improvement in power in case of a four stroke diesel engine with the help of a supercharger may be expected in the range

Q. With single Hooke's joint it is possible to connect two shafts, the axes of which have an angular misalignment up to

Question analytics