M

Mr. Dubey • 100.64K Points
Coach

Q. What can be the maximum pressure to be given to plastic for blow molding process?

  • (A) 700 kpa
  • (B) 750 kpa
  • (C) 800 kpa
  • (D) 850 kpa
Share
Explanation by: Mr. Dubey
air with an extreme amount of pressure, when is needed, it might mean the material is thicker and denser. the amount of pressure that can be provided depends totally on the material. the maximum pressure that can be provided in blow molding process is 800 kpa.

You must be Logged in to update hint/solution

Discusssion

Login to discuss.

Related MCQs

Q. For small temperature difference, the heat transfer rate as per Newton's law of cooling is proportional to (where, Δt = excess temperature)

Q. Eye bolts are used for

Q. Acetone is to be removed from air in an isothermal dilute absorber using pure water as solvent. The incoming air contains 5 mole% of acetone (yin = 0.

Q. The compressor capacity with decrease in suction temperature

Q. The speed of the engine is increased or decreased by operating

Q. For transmission lines the standing wave ratio is the ratio of

Q. Steam turbines are used for ____________

Q. The locomotive wheel tires are fitted as

Q. Size of boiler tubes is specified by

Q. When the work is by on the gases, which of the following effect is observed on the turning moment diagram?

Question analytics