M

Mr. Dubey • 100.64K Points
Coach

Q. Which of the following is not a type of blow molding process?

  • (A) injection blow molding
  • (B) extrusion blow molding
  • (C) multi-smaller blow molding
  • (D) multi-larger blow molding
Share
Explanation by: Mr. Dubey
blow molding basically is a process of inflation of air under pressure into the plastics inside the mold cavity. there are only three known types of blow molding,

You must be Logged in to update hint/solution

Discusssion

Login to discuss.

Related MCQs

Q. Coefficient of contraction is the__________

Q. Why are lead compounds added in petrol?

Q. The pH value of concentrated sulphuric acid could be expected between

Q. Chemisorption (chemical adsorption) is

Q. Hardening by carburizing is limited to

Q. Knuckle Joint can’t be used to connect two intersecting rods.

Q. Which of the following is an advantage of a separate water carriage system?

Q. Calculate the moment of inertia of the thin spherical shell having a mass of 73 kg and diameter of 36 cm.

Q. A jack having 2 cm as the diameter of the screw at the root of the thread, may be expected to safely lift a load of about

Q. Which one of the following factors will not assist in smooth running of a compression ignition engine?

Question analytics