M

Mr. Dubey • 100.64K Points
Coach

Q. Which of the following is not an application of blow molding process?

  • (A) toy bodies
  • (B) door liners
  • (C) bottles
  • (D) pipes
Share
Explanation by: Mr. Dubey
among the following, only door liners is not an application of blow molding process. internal door liners are made using thermoforming process, while toy bodies, bottles and pipes are made using blow molding process.

You must be Logged in to update hint/solution

Discusssion

Login to discuss.

Related MCQs

Q. Flaw sizing by the 6 dB drop technique is applicable to:

Q. Which of the following property is desirable in parts subjected to shock and impact loads?

Q. What is STSC1?

Q. In the fuel injection pump of a Diesel engine, the fuel injection timing is adjusted by adjusting the

Q. Cracks which are caused by alternating stresses above a critical level are called:

Q. Attack of steel is increased by

Q. Which of the following acts as a step up transformer in the ignition circuit of a petrol engine?

Q. Among liquids, water has a comparatively high value of thermal conductivity, due to its

Q. The portion of a test piece which is represented by the CRT screen area from zero to the rightmost edge of the initial pulse is called:

Q. In an induction motor, when the number of stator slots is equal to an integral number of rotor slots

Question analytics