M

Mr. Dubey • 100.64K Points
Coach

Q. Shrinkage allowance does not depend on which of the following factor?

  • (A) moulding method
  • (B) casting dimension
  • (C) pouring temperature of molten metal
  • (D) amount of finish required
Share
Explanation by: Mr. Dubey
shrinkage allowance does not depend on the amount of finish required. the amount of finish needed on the machining portion is a factor on which machining allowance depends. shrinkage allowance depends on all other remaining factors.

You must be Logged in to update hint/solution

Discusssion

Login to discuss.

Related MCQs

Q. 4-stroke engine has one power stroke per 2 revolutions hence turning moment diagram is uniform.

Q. According to ASTM E709-95 the alkalinity of conditioned water shall not exceed:

Q. If the supply freq of an induction motor is increased by 5%, the synchronous speed will

Q. When both pinion and gear are made of the same material, then from the design point of view

Q. The approximate straight line mechanism is a

Q. During ultrasonic testing by the immersion method, it is frequently necessary to angulate the search unit when a discontinuity is located at an angle

Q. Two plates spaced 150 mm apart are maintained at 1000°C and 70°C. The heat transfer will take place mainly by

Q. The gear ratio in the differential unit of a passenger car is of the order of

Q. Which of the following is not fixed by the process requirements, in the design of absorbers?

Q. The film co-efficient between condensing vapour and metal wall increases with

Question analytics