Q. Additives can be used for the non-ferrous application to avoid the poor collapsibility of the mould.

  • (A) true
  • (B) false
  • (C) ---
  • (D) ---
💬 Discuss
✅ Correct Answer: (B) false
Explanation: in co2 moulding, poor collapsibility of the mould is a major disadvantage. although some additives are used for the improvement in the properties of

Published by Mr. Dubey ⭐ 104.85K Points at 20-Sep-2023 12:46 pm in Manufacturing Technology

Explanation by: Mr. Dubey
in co2 moulding, poor collapsibility of the mould is a major disadvantage. although some additives are used for the improvement in the properties of

💬 Discussion

Related MCQs

Q. Cotter joint can be used to connect two rods for torque transmission purpose.

Q. The lower temperature limit for mercury thermometer is

Q. Phase, advancers for power factor improvement are generally used for

Q. For the same process conditions, the reflux ratio of an unlagged distillation column

Q. Which residual field is most difficult to demagnetise?

Q. The basic tool in work study is

Q. Prandtl number is the ratio of

Q. The rate of heat loss through a furnace wall is 1000 kcal per hour when inside temperature is 1000?C and outside wall temperature is 500?C. What shoul

Q. In stress relief annealing, the annealing temperature is relatively low.

Q. What is the minimum pressure allowed to be given to the injection molding process?

📊 Question Analytics

👁️
598
Total Visits
📽️
3 y ago
Published
🎖️
Mr. Dubey
Publisher
📈
95%
Success Rate