Q. How much does the distortion allowance vary?

  • (A) 1mm to 10mm
  • (B) 2mm to 20mm
  • (C) 1mm to 15mm
  • (D) 2mm to 15mm
💬 Discuss
✅ Correct Answer: (B) 2mm to 20mm
Explanation: in distortion allowance, the amount goes on to vary from 2mm to 20mm. this allowance depends on the shape of the casting that is being used. it also depends on the size of the cast and the material that is being employed for the casting.

Published by Mr. Dubey ⭐ 111.54K Points at 20-Sep-2023 12:46 pm in Manufacturing Technology

Explanation by: Mr. Dubey
in distortion allowance, the amount goes on to vary from 2mm to 20mm. this allowance depends on the shape of the casting that is being used. it also depends on the size of the cast and the material that is being employed for the casting.

💬 Discussion

Related MCQs

Q. What is the pressure of H2 with compressibility 0.6, molar volume 5 liter/mole at 27oC?

Q. How many types of feedwater heaters are present?

Q. Prototyping involves

Q. Synthetic rubber is made of

Q. The term ‘drag out losses’ refers to:

Q. At which part of the precision straight edge is generally lapped?

Q. If spring index=2.5, what can be concluded about stresses in the wire?

Q. Which of the following is not a self-generating transducer?

Q. Soya is a meat analogue. This means it can be used with certain meat stuffing to increase the bulk as it has a similar texture as that of meat. This i

Q. If knuckle joint is to fail by crushing failure of pin in fork, then determine the diameter of knuckle pin when 50kN axial tensile force act on rods.

📊 Question Analytics

👁️
730
Total Visits
📽️
3 y ago
Published
🎖️
Mr. Dubey
Publisher
📈
95%
Success Rate