📊 Mechanical Measurements
Q. The reliability of an instrument means
  • (A) The maximum useful life of an instrument
  • (B) The service of an instrument between two repairs
  • (C) The range in which the characteristics of an instrument remain linear
  • (D) The degree to which repeatability continues to remain within specified limits
💬 Discuss
✅ Correct Answer: (D) The degree to which repeatability continues to remain within specified limits

You must be Logged in to update hint/solution

💬 Discussion

Related MCQs

Q. If the temperature of the source is increased, the efficiency of the Carnot engine

Q. The purpose of adding a wetting agent to an immersion bath is:

Q. Which of the following is normally prohibited as a method of removing excess penetrant when using the solvent removable penetrant process?

Q. A body is vibrating with simple harmonic motion of aplitude 5 cm frequency 10 vibrations per second. The maximum value of velocity in cm/s will be

Q. For a 7.6 cm (3 inches) diameter bar how much current is needed to magnetize the bar for the detection of longitudinal discontinuities:

Q. Which type of job motion is there in drilling operation?

Q. Solid shaft is costlier than hollow shaft of same weight.

Q. The degree of fementation in brewing pressure can be measured by

Q. which keyword is use to check exception?

Q. In steady state forced vibrations, the amplitude of vibrations at resonance is __________ damping coefficient.

📊 Question Analytics

👁️
679
Total Visits
📽️
2 y ago
Published
🎖️
Mr. Dubey
Publisher
📈
82%
Success Rate