Q. Although semi-conductor strain gauges have high gauge factor still these are not preferred due to

  • (A) Difficulties in connections and high cost of auxiliary equipment
  • (B) Small size and high cost
  • (C) Small size and high cost
  • (D) Non-linearity and sensitivity to temperature fluctuations
💬 Discuss
✅ Correct Answer: (D) Non-linearity and sensitivity to temperature fluctuations

Published by Mr. Dubey ⭐ 111.54K Points at 21-Sep-2023 06:42 pm in Mechanical Measurements

You must be Logged in to update hint/solution

💬 Discussion

Related MCQs

Q. Which of the following statement is false?

Q. Lead screens improve mainly the of the final radiograph:

Q. The Knudsen diffusivity is dependent on the

Q. If you were on one side of a wireframe cube looking toward a solid sphere on the other side of the cube, you would see

Q. The processes in a Rankine cycle are

Q. An induction motor when started on load, it does not accelerate up to full speed but runs at 1/7th of the rated speed. The motor is said to be

Q. The minimum change in the measured variable which produces an effective response of the instrument is known as

Q. Supercharging is normally done in

Q. AA display which shows the initial pulse and the front surface echo with a fairly wide space between the two would be considered:

Q. The general homogeneous coordinate representation can also be written as

📊 Question Analytics

👁️
151
Total Visits
📽️
3 y ago
Published
🎖️
Mr. Dubey
Publisher
📈
95%
Success Rate