Q. Which of the following option is incorrect about interchangeability?

  • (A) increase output
  • (B) increase cost of production
  • (C) useful in mass production
  • (D) assembly time increases
💬 Discuss
✅ Correct Answer: (D) assembly time increases
Explanation: an interchangeable part is one that can be replaced with a similar part manufactured to the same drawing. it can be used in mass production with an economic oriented approach. assembly time decreases as mating parts are interchangeable.

Published by Mr. Dubey ⭐ 111.54K Points at 21-Sep-2023 06:50 pm in Metrology and Measurements

Explanation by: Mr. Dubey
an interchangeable part is one that can be replaced with a similar part manufactured to the same drawing. it can be used in mass production with an economic oriented approach. assembly time decreases as mating parts are interchangeable.

💬 Discussion

Related MCQs

Q. Co2 moulding is a kind of sand moulding, but it is not economical than the green sand moulding.

Q. The instruction that represents the ‘rotate source, count’ is

Q. Naphtha is a volatile colourless product obtained from

Q. In a diesel engine the inlet pressure is more than the atmospheric pressure. Therefore; it can be concluded that

Q. If the pressure drop(ΔP) is 200 units, the flux(J) is 100 units,what is the hydraulic membrane permeability?

Q. Thermal equilibrium means that the flow of steam is ____________

Q. From inlet to exit of steam nozzle, the pressure

Q. A car is travelling at 90 km/hour on a rough road where the coefficient of friction between the road and the tyre is 0.5. The distance the car will sk

Q. Liquids lighter than water (such as petroleum oils) have API gravities numerically

Q. Which type of penetrant process would be best suited to the detection of wide, shallow discontinuities?

📊 Question Analytics

👁️
804
Total Visits
📽️
3 y ago
Published
🎖️
Mr. Dubey
Publisher
📈
83%
Success Rate