Q. Which of the following is used to check change in ocular lines position due to column rotation in universal micrometer?

  • (A) dial indicator
  • (B) slip gauges
  • (C) control shaft
  • (D) universal microscope
💬 Discuss
✅ Correct Answer: (C) control shaft
Explanation: a special control shaft is used to check this where a right angled blade is provided at right angle to shaft diameter line. the ocular line is made to coincide with the blade and the column is titled, the shift in position of the ocular line is noted, this shift is the required error.

Published by Mr. Dubey ⭐ 111.54K Points at 21-Sep-2023 06:50 pm in Metrology and Measurements

Explanation by: Mr. Dubey
a special control shaft is used to check this where a right angled blade is provided at right angle to shaft diameter line. the ocular line is made to coincide with the blade and the column is titled, the shift in position of the ocular line is noted, this shift is the required error.

💬 Discussion

Related MCQs

Q. In carburetor, Choke is incorporated

Q. The tundish is a

Q. The Reynolds number of the liquid was increased 100 fold for a laminar falling film used for gas-liquid contacting. Assuming penetrating theory is app

Q. In an electron beam, the average kinetic energy of an electron is given by

Q. Low grade fuels have

Q. The angle of friction is

Q. When the connected members are very yielding (soft gasket) as compared to the bolt, then the resultant load on the bolt will be equal to the

Q. The relative volatility of a binary mixture at the Azeotropic composition is

Q. Deterioration of penetrant material performance may be caused by which of the following?

Q. What is the relation between heat rejection ratio (HRR) and Coefficient of performance (COP)?

📊 Question Analytics

👁️
897
Total Visits
📽️
3 y ago
Published
🎖️
Mr. Dubey
Publisher
📈
91%
Success Rate