Q. Which of the following is true for the calibration of instruments?

  • (A) in casting and fabrication shops the measurements made are of more precise nature as compared to those made in machine shop and tool room
  • (B) periodical calibration is made for optical measuring instruments
  • (C) there is no need of periodic calibration in universal microscope
  • (D) preventive maintenance is not necessary for optical measuring instruments
💬 Discuss
✅ Correct Answer: (B) periodical calibration is made for optical measuring instruments
Explanation: in machine shop and tool room the measurements made are of more precise than those made in casting and fabrication shops, so instruments used in these shops require more frequent calibration. annual programme can be made for periodical calibration and for general preventive maintenance in optical measuring instruments like universal microscope.

Published by Mr. Dubey ⭐ 111.54K Points at 21-Sep-2023 06:51 pm in Metrology and Measurements

Explanation by: Mr. Dubey
in machine shop and tool room the measurements made are of more precise than those made in casting and fabrication shops, so instruments used in these shops require more frequent calibration. annual programme can be made for periodical calibration and for general preventive maintenance in optical measuring instruments like universal microscope.

💬 Discussion

Related MCQs

Q. A long helical spring having a spring stiffness of 12 kN/m and number of turns 20, breaks into two parts with number of turns 10 each in both the part

Q. If the radius of gyration of a compound pendulum about an axis through e.g. is more, then its frequency of oscillation will be

Q. In a Porter governor, the balls are attached to the extension of lower links.

Q. If the major quantium number of an atom is three, it possesses

Q. The dimensions of gravitational constant G

Q. Total solid impurities in feed water for a boiler depend upon

Q. In forced feed lubrication system the device used to guard against excessive oil pressure is known as

Q. If a square key and the shaft are to be of the same material and of equal strength, the length of key would be (d = dia. Of shaft)

Q. A 66 kV transmission line carrying power to a distance of 120 kilometre will be termed as

Q. Minimum horsepower of pump required for filling 50m3 water tank, 20 metres high from ground in 30 minutes by lifting water from a well 5 metres below

📊 Question Analytics

👁️
743
Total Visits
📽️
3 y ago
Published
🎖️
Mr. Dubey
Publisher
📈
84%
Success Rate