Q. What is the maximum permissible error in wear of centres?

  • (A) 0.04 mm
  • (B) 0.03 mm
  • (C) 0.02 mm
  • (D) 0.01 mm
💬 Discuss
✅ Correct Answer: (D) 0.01 mm
Explanation: the centres are set and checked for straightness. it can be observed while rotating the centres. the maximum error permissible for wear of centres is 0.01 mm.

Published by Mr. Dubey ⭐ 111.54K Points at 21-Sep-2023 06:51 pm in Metrology and Measurements

Explanation by: Mr. Dubey
the centres are set and checked for straightness. it can be observed while rotating the centres. the maximum error permissible for wear of centres is 0.01 mm.

💬 Discussion

Related MCQs

Q. A body is executing simple harmonic motion of amplitude 1 cm. Its velocitywhile passing through the central point is 10 mm/sec. Its frequency will be

Q. What are turbo-compound engines?

Q. which of the following are language processors

Q. Plastic flow in ductile materials

Q. Which of the following offers best resistance to knocking in S.I. engines?

Q. In centrifugal casting, a movable pouring basin is employed for the pouring of molten metal.

Q. The inlet value of a four stroke I.C. engine, in actual practice, should close

Q. The heat loss in a boiler takes place in the form of

Q. If a solid sphere rolls on a horizontal surface, then the ratio of its rotational kinetic energy to its total kinetic energy is

Q. The efficiency of hydraulic braking system is

📊 Question Analytics

👁️
892
Total Visits
📽️
3 y ago
Published
🎖️
Mr. Dubey
Publisher
📈
96%
Success Rate