M

Mr. Dubey • 100.64K Points
Coach

Q. Where does wire is placed in a measurement of diameter using the technique of gauging wide diameter from the diffraction pattern formed in a laser beam?

  • (A) between collimator and lens
  • (B) between collimator and source
  • (C) between collimator and plane of measurement
  • (D) between collimator and detectors
Share
Explanation by: Mr. Dubey
gauging wide diameter is a method of the measurement of the thin wire diameter with the use of the interference fringes resulting from diffraction by the wire in the laser beam. output variation from the photodetector is caused by changes in fringes.

You must be Logged in to update hint/solution

Discusssion

Login to discuss.

Related MCQs

Q. In which magnetizing method is the current passed directly through the part, thereby setting up a magnetic field at right angles to the current flow?

Q. In a turning moment diagram, the variations of energy above and below the mean resisting torque line is called

Q. In sub-cooled boiling,

Q. A line AB with end points A (2, 1) & B (7, 6) is to be moved by 3 units in x-direction & 4 units in y-direction. Calculate new coordinates of

Q. A four wheel drive automobile has

Q. Cereals are the major source of food in the world.

Q. When load is placed in three phase induction motor its current

Q. Which of the following was not included as a factor or variable which has an effect on personnel forecasting techniques?

Q. A vacuum of 712 mm was obtained with the barometer reading 753 mm of mercury. The corrected vacuum to a standard barometer of 760 would be

Q. In an actual SI engine the pumping loss with respect to speed

Question analytics