Q. Which of the following is not true about concentricity of teeth?

  • (A) fluctuating velocity will be noticed when not concentric
  • (B) can be checked by using projector
  • (C) inaccuracy of parts when not concentric
  • (D) should be tested to ensure the proper heat treatment
💬 Discuss
✅ Correct Answer: (D) should be tested to ensure the proper heat treatment
Explanation: concentricity of teeth is an important item and should be checked to ensure that the set up and equipment is in good order. when teeth are not concentric then fluctuating velocity will be noticed on the pitch line while transmitting motion.

Published by Mr. Dubey ⭐ 104.82K Points at 21-Sep-2023 06:51 pm in Metrology and Measurements

Explanation by: Mr. Dubey
concentricity of teeth is an important item and should be checked to ensure that the set up and equipment is in good order. when teeth are not concentric then fluctuating velocity will be noticed on the pitch line while transmitting motion.

💬 Discussion

Related MCQs

Q. In case of an opposed piston engine the combustion chamber

Q. Ice is slippery when a man walks on it for

Q. When a longitudinal wave is incident upon an inclined interface between zero degrees and the first critical angle:

Q. Hot spots are

Q. If air (a non-condensing gas) is present in a condensing vapor stream, it will __________ the condensation rate of vapor.

Q. The limitation of the first law is

Q. Which of the following element has hexagonal close packed structure?

Q. Electronic structure of a material is generally studied by

Q. In STL files when chord length decrease then accuracy _______

Q. A point moves in such a manner that its distance from a fixed point is equal to its distance from a fixed line multiplied by a constant greater than o

📊 Question Analytics

👁️
134
Total Visits
📽️
3 y ago
Published
🎖️
Mr. Dubey
Publisher
📈
93%
Success Rate