Q. Which of the following statement is true about inspection of gear?

  • (A) profile is determined by functional inspection
  • (B) backlash is determined by analytic inspection
  • (C) analytic test require running test of gear
  • (D) thickness of tooth is measured by functional inspection
💬 Discuss
✅ Correct Answer: (B) backlash is determined by analytic inspection
Explanation: functional type of inspection is done by running test of gear with another gear. it is used to determine noise level and composite variation. analytical method is used to determine backlash, lead and runout.

Published by Mr. Dubey ⭐ 104.82K Points at 21-Sep-2023 06:51 pm in Metrology and Measurements

Explanation by: Mr. Dubey
functional type of inspection is done by running test of gear with another gear. it is used to determine noise level and composite variation. analytical method is used to determine backlash, lead and runout.

💬 Discussion

Related MCQs

Q. Maximum water velocity in tubes of a 1-2 shell and tube heat exchanger may be around __________ metres/second.

Q. The formula, NI = 45000/(L/D), is used to calculate the proper magnetising current for:

Q. What is used to heat the feed water which is used for recirculation through tubes?

Q. A disturbing mass m1 attached to the rotating shaft may be balanced by a single mass m2 attached in the same plane of rotation as that of m1, such tha

Q. Pick out the wrong statement.

Q. The connecting rod bolts are tightened up so that tightening stress

Q. Minimum horsepower of pump required for filling 50m3 water tank, 20 metres high from ground in 30 minutes by lifting water from a well 5 metres below

Q. The valve rod in a steam engine is connected to an eccentric rod by

Q. A A larger diameter crystal results in:

Q. Free expansion is irreversible.

📊 Question Analytics

👁️
222
Total Visits
📽️
3 y ago
Published
🎖️
Mr. Dubey
Publisher
📈
92%
Success Rate