Q. Which of the following is not true for the method of measurement of surface finish by micro interferometer?

  • (A) optical flat is used
  • (B) monochromatic source of light is used
  • (C) depth of defect can’t be measured
  • (D) interference lines plays an important role in identification of the defect
💬 Discuss
✅ Correct Answer: (C) depth of defect can’t be measured
Explanation: in the method of inspection of surface by using micro interferometer, an optical flat is used which is placed on the surface to be examined and illuminated by using monochromatic light. interference bands are studied by using a microscope.

Published by Mr. Dubey ⭐ 111.54K Points at 21-Sep-2023 06:51 pm in Metrology and Measurements

Explanation by: Mr. Dubey
in the method of inspection of surface by using micro interferometer, an optical flat is used which is placed on the surface to be examined and illuminated by using monochromatic light. interference bands are studied by using a microscope.

💬 Discussion

Related MCQs

Q. The speed of sound through water is nearly

Q. The most significant difference in two X ray beams produced at different kV settings is:

Q. What is the Euler number of the image shown below?

Q. Annealing treatment is normally used for

Q. In defining the temperature scale, the standard reference point is taken as

Q. A heat engine using lake water at 12° C as source & the surrounding atmosphere at 2°C as sink executes 1080 cycles per min. If the amount

Q. A wound watch spring possesses energy in the form of

Q. Film coefficient is defined as Inside diameter of tube

Q. An engine operates between temperatures of 900K and T1 and another engine between T2 and 400K. For both to do equal work, value of T2 will be

Q. Resistance to fatigue of a material is measured by

📊 Question Analytics

👁️
284
Total Visits
📽️
3 y ago
Published
🎖️
Mr. Dubey
Publisher
📈
87%
Success Rate