Q. What is the likely result of incomplete removal of all excess penetrant from the test piece surface?

  • (A) Formation of false indications
  • (B) Formation of relevant indications
  • (C) Exaggeration of the size of relevant indications
  • (D) None of the above
💬 Discuss
✅ Correct Answer: (A) Formation of false indications

Published by Mr. Dubey ⭐ 111.54K Points at 21-Sep-2023 07:17 pm in Non Destructive Testing and Evaluation

You must be Logged in to update hint/solution

💬 Discussion

Related MCQs

Q. When the material of key and shaft is same, and the width of key is one-fourth of the diameter of shaft (d), then length of key will be

Q. When the throttle is suddenly opened, the mixture of the simple carburetor tends to become

Q. The ultimate strength of steel in tension in comparison to shear is in the ratio of

Q. Typical frequencies which might be used to perform ultrasonic testing of ferrous and non-ferrous welds are:

Q. Which of the following would be detrimental to radiographic image sharpness?

Q. In angular contact bearings, bearings are required to take thrust load in both directions.

Q. An inspection for surface and subsurface discontinuities in ferromagnetic welds would best be accomplished by which of the following techniques?

Q. In a gas turbine rotor a radial stress of 300 kg/sq cm tensile and 500 kg/sq cm tangential stress have been found at a point. The maximum shear stress

Q. Based upon the nature of heat exchange process, the heat exchangers are classified into how many categories

Q. In the levers of third type, the mechanical advantage is __________ one.

📊 Question Analytics

👁️
581
Total Visits
📽️
3 y ago
Published
🎖️
Mr. Dubey
Publisher
📈
95%
Success Rate