Q. Dry developer is applied:

  • (A) Immediately before removal of excess penetrant
  • (B) Immediately after removal of excess penetrant
  • (C) After drying of the part
  • (D) For maximum sensitivity results
💬 Discuss
✅ Correct Answer: (C) After drying of the part

Published by Mr. Dubey ⭐ 104.82K Points at 21-Sep-2023 07:17 pm in Non Destructive Testing and Evaluation

You must be Logged in to update hint/solution

💬 Discussion

Related MCQs

Q. Conservancy system is a highly unhygienic system, causing insanitary conditions.

Q. The stress in the threaded part of the bolt will be __________ as compared to the shank.

Q. The area under the load curve represents

Q. A power cycle using steam as working fluid consist of i) constant pressure heat addition ii)adiabatic expansion iii) constant pressure heat rejection

Q. In which of the following type of flame, oxygen is in excess proportion with acetylene?

Q. X ray intensity is a function of :

Q. Mechanical efficiency is the ratio of

Q. The most important penetrant test processing time to control is:

Q. A perfect gas having p1= 0.1 M/mm², v1=0.18 m³, T1=20°C is compressed to 1/10 of volume in an isothermal process. The change in entropy

Q. In a steam engine, the earlier cut-off with a simple slide valve may be obtained by increasing the steam lap and the angle of advance of the eccentric

📊 Question Analytics

👁️
807
Total Visits
📽️
3 y ago
Published
🎖️
Mr. Dubey
Publisher
📈
80%
Success Rate