Q. Which of the following is the proper first step in removal of excess penetrant when using the solvent removable penetrant process?

  • (A) Immerse the test piece in solvent
  • (B) Spray the test piece with water
  • (C) Wipe the test piece surface with clean, lint free towels slightly moistened
  • (D) All of the above is correct
💬 Discuss
✅ Correct Answer: (C) Wipe the test piece surface with clean, lint free towels slightly moistened

Published by Mr. Dubey ⭐ 104.84K Points at 21-Sep-2023 07:17 pm in Non Destructive Testing and Evaluation

You must be Logged in to update hint/solution

💬 Discussion

Related MCQs

Q. The frictional torque transmitted in a truncated conical pivot bearing, considering uniform wear, is

Q. Which of the following parameters of the fluid is not very important, while deciding its route in a shell and tube heat exchanger?

Q. Air ducts are provided in armature core to

Q. Which is the first aspect which needs to be considered in the Mechatronics design process?

Q. Mass transfer co-efficient 'K' according to penetration theory varies with mass diffusivity as

Q. The heater in the vacuum forming process is heated up to 90°C.

Q. In a tug of war, five men pull a rope to the left at A and six moen pull the rope at B. A weight of 5 kg is hung vertically from the centre of the rop

Q. In which component a ball or roller bearing cannot be used?

Q. Entropy is a

Q. The pitch of 24 mm diameter metric threads would be

📊 Question Analytics

👁️
969
Total Visits
📽️
3 y ago
Published
🎖️
Mr. Dubey
Publisher
📈
89%
Success Rate