Q. Which of the following is not normally recommended?

  • (A) Performing a fluorescent penetrant test following a visible penetrant test?
  • (B) Performing a visible penetrant test following a fluorescent test
  • (C) Removing excess penetrant with a water spray
  • (D) Removing excess penetrant with towels moistened with solvent
💬 Discuss
✅ Correct Answer: (A) Performing a fluorescent penetrant test following a visible penetrant test?

Published by Mr. Dubey ⭐ 111.54K Points at 21-Sep-2023 07:17 pm in Non Destructive Testing and Evaluation

You must be Logged in to update hint/solution

💬 Discussion

Related MCQs

Q. Shaft revolving in a bearing is the following type of pair

Q. Flooding in a distillation column is detected by a sharp

Q. In wave winding, the number of parallel paths of armature winding is

Q. The function of oil scraper rings is to

Q. Stacked packing compared to dumped packing

Q. As the number of cylinders on multi-cylinder engines increases the power to weight ratio

Q. The reason for preferring packed towers over plate towers in distillation practice is that the packed tower operation gives

Q. The thermal efficiency of a dual cycle engine with fixed compression ratio and fixed quantity of het and with increase in pressure ratio, will

Q. The property which enables metals to be drawn into wire is known as

Q. The property of a bearing material which has the ability to accommodate small particles of dust, grit etc. without scoring the material of the journal

📊 Question Analytics

👁️
309
Total Visits
📽️
3 y ago
Published
🎖️
Mr. Dubey
Publisher
📈
81%
Success Rate