📊 Non Destructive Testing and Evaluation
Q. Which of the following is a disadvantage of the wet method?
  • (A) It is the most sensitive method for detection of very fine surface cracks
  • (B) Rapid testing of large quantities of small test pieces
  • (C) Readily adaptable to mechanised equipment
  • (D) Excellent detection of completely subsurface discontinuities
💬 Discuss
✅ Correct Answer: (D) Excellent detection of completely subsurface discontinuities

You must be Logged in to update hint/solution

💬 Discussion

Related MCQs

Q. In the free convection regime of pool boiling, the heat flux is proportional to

Q. Which of the following is intended to be a ‘first cut’ or rough inspection device to be followed by more precise evaluation of any discont

Q. Non-isotropic conductivity is exhibited in case of

Q. As transducer crystal thickness decreases:

Q. The molecular structure of the straight-run gasoline is changed by

Q. Winds caused by greater solar heating of the earth's surface near the equator than near the northern or southern poles, are known as

Q. The area under the load curve represents

Q. Which of the following equipments is not used in liquid-liquid extraction?

Q. A regenerative Rankine cycle may approach efficiency of a Carnot cycle between same temperature by

Q. The speed at which the piece advances through the cutter is called

📊 Question Analytics

👁️
480
Total Visits
📽️
3 y ago
Published
🎖️
Mr. Dubey
Publisher
📈
87%
Success Rate