M

Mr. Dubey • 100.64K Points
Coach

Q. The normal range of steel that is radiographed using Ir-192 is:

  • (A) 5 mm–20 mm
  • (B) 25 mm – 75 mm
  • (C) 0.5 mm – 5 mm
  • (D) 75 mm – 150 mm
Share

No solution found for this question.
Add Solution and get +2 points.

You must be Logged in to update hint/solution

Discusssion

Login to discuss.

Related MCQs

Q. Plastic are

Q. What is the relation between heat rejection ratio (HRR) and Coefficient of performance (COP)?

Q. If mach number is less than one then its flow is

Q. CANDU stands for

Q. In which of the following state manufacturing unit of M/S Bharat Heavy Electricals Ltd. Is not located?

Q. Multi-storey buildings are used for

Q. The helical spring ad wire of helical torsion spring, both are subjected to torsional shear stresses.

Q. The main reason for using a casting is that:

Q. A good Cobalt-60 shot is made on a 7.6 cm (3 inches) steel casting using an exposure time of 10 minutes and a source-to-film distance of 91.5 (36 inch

Q. The diameter of knuckle pin in a knuckle joint is usually taken as (where d = Diameter of the rod)

Question analytics