Q. Calculate the refracted shear wave angle in steel [VS = 0.323cm/microsec] for an incident longitudinal wave of 45.7 degrees in Plexiglas [VL = 0.267cm/microsec]

  • (A) 64 degrees
  • (B) 45.7 degrees
  • (C) 60 degrees
  • (D) 70 degrees
💬 Discuss
✅ Correct Answer: (C) 60 degrees

Published by Mr. Dubey ⭐ 110.47K Points at 21-Sep-2023 07:19 pm in Non Destructive Testing and Evaluation

You must be Logged in to update hint/solution

💬 Discussion

Related MCQs

Q. Total heat of a substance is also known as

Q. The water carriage system is a hygienic system without any bad smell.

Q. A thermometer has a time constant of 3.5 seconds. It is quickly taken from a temperature 0?C to water bath at 100?C. What temperature will be indicate

Q. Extremely large or small volumes of fluids are generally best routed through the shell side of a shell and tube heat exchanger, because of the

Q. The power supplied to domestic consumers is at 220 volts. This represents

Q. Gamma ray or high voltage X ray radiography, using film without lead screens, is likely to result in:

Q. A hot wire anemometer is used to measure

Q. When a conductor is suspended between two supports at the same level it taken the shape of

Q. The angle through which a gear turns from the beginning of contact of a pair of teeth until the contact reaches the pitch point, is known as

Q. The expression nRT/V is called the partial pressure of a gas.

📊 Question Analytics

👁️
810
Total Visits
📽️
3 y ago
Published
🎖️
Mr. Dubey
Publisher
📈
95%
Success Rate