M

Mr. Dubey • 100.64K Points
Coach

Q. To avoid interfering surface waves, low frequencies should only be used on:

  • (A) Polished surfaces
  • (B) Castings
  • (C) Flat surfaces
  • (D) Non-polished surfaces
Share

No solution found for this question.
Add Solution and get +2 points.

You must be Logged in to update hint/solution

Discusssion

Login to discuss.

Related MCQs

Q. Lubricant is not required in

Q. The essential gradient of any hardened steel is

Q. A self-socking screw is one which

Q. Tubes are held between top and bottom tube sheets in Calandria type evaporator by keeping

Q. Correction is applied to LMTD for __________ flow.

Q. In a vibrating system, if the actual damping coefficient is 40 N/m/s and critical damping coefficient is 420 N/m/s, then logarithmic decrement is equa

Q. Yield point in static loading as compared to that in fatigue loading is

Q. In what is water in high pressure boiler circulated through?

Q. Which of the following nutrients are lost in all steps of food engineering (including packaging and freezing)?

Q. From which of the following is known as non-contact sensor

Question analytics